Directions

Effectiveness increases with each application

DO NOT Wash Your Hunting Clothes After Applying WRAITH

Virtually every scent elimination or other anti-detection product for hunters on the market breaks down and loses its effectiveness over time requiring you to continually reapply. WRAITH is different. Its nanoparticles penetrate the clothing and stay there. Reapplying literally makes WRAITH work even better because it is additive! You will be less likely to be detected at the end of the season than at the beginning. However, washing your hunting clothes will diminish this additive nature, requiring you to start over. If you must clean your hunting clothes, dip them in a bath of WRAITH.

Cold Weather Warning

DO NOT apply WRAITH inside your clothing or on base layers when hunting in cold weather (below 60°F). WRAITH controls radiated heat so effectively that it produces a cooling effect and can lower your body temperature. Apply to outer layers only.

MIXING DIRECTIONS

  • Fill the 23 oz bottle 1/2 full with water
  • Add .50 oz of WRAITH™ Formula (1/4 scoop) or (1) heaping tablespoon
  • Fill water to the midpoint of the bottle neck
  • Shake vigorously until fully dissolved

IMPORTANT: Always re-shake before each use

DIRECTIONS FOR USE

  • Apply WRAITH™ generously to outerwear and gear front and back coverage.
  • Allow gear to hang and fully dry before use.

FIELD APPLICATION

  • Reapply in the field
  • Use prior to your final approach to your stand or blind

Shelf Life

The powder has virtually unlimited shelf life.

Dip application

Another way to use Wraith. Instead of spraying each piece, soak the whole kit at once.

  • Fill a tub with water ... any water works, creek water is fine
  • Add Wraith and mix it through (three to four ounces from the 16 oz Shaker is what's used in the video)
  • Submerge your gear ... jacket, pack, gloves, even boots
  • Work it around, then let it soak about an hour
  • Hang everything up and let it dry

Play video

In the field

Concentrated powder formula — just add water.
  1. A hunter kneeling on the forest floor, measuring WRAITH powder from the 32 oz canister with the scoop

    Mix

    Fill your 23 oz bottle 1/2 full with water. Add one heaping tablespoon of Wraith Formula, fill to the midpoint of the bottle neck, and shake vigorously until fully dissolved.

  2. A hunter crouched over a hunting pack, holding the 4 oz WRAITH refill pouch, spray bottle on the ground beside him

    Treat

    Apply generously to outerwear and gear — front and back coverage. Allow gear to hang and fully dry before use.

  3. A hand spraying WRAITH from the 23 oz bottle onto a leather hunting boot in the leaf litter

    Reapply

    Reapply in the field. Always re-shake before each use.

  4. A hunter walking out through green timber with a pack over one shoulder and the WRAITH spray bottle in hand

    Final approach

    Use prior to your final approach to your stand or blind.

COLD WEATHER WARNING: DO NOT apply inside clothing or base layers when temperatures are below 60°F. WRAITH™ produces a cooling effect that may lower body temperature in cold conditions.